LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> Edge SE, 2.0 9 >> Repair and Diagnosis >> Engine Performance >> Engine Ignition System - 2.0L GTDI >> Removal And Installation >> Ignition Coil-On-Plug >> Removal and Installation

Removal and Installation

  1. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
  2. Remove the nut and position the EVAP canister purge valve aside.
    • To install, tighten to 10 Nm (89 lb-in).
      Fig 1: Locating EVAP Canister Purge Valve And Nut
      G07930769Courtesy of FORD MOTOR CO.
  3. Disconnect the wire retainers and position aside the engine wire harness.
    Fig 2: Locating Engine Wire Harness Wire Retainers
    G07930770Courtesy of FORD MOTOR CO.
  4. NOTE: Use compressed air to remove any foreign material from the ignition coil-on-plug and surrounding area before removing the ignition coil-on-plug.
  5. Disconnect the 4 ignition coil-on-plug electrical connectors.
  6. NOTE: When removing the ignition coil-on-plugs, a slight twisting motion will break the seal and ease removal.
  7. Remove the 4 bolts and the 4 ignition coil-on-plugs.
    • To install, tighten to 8 Nm (71 lb-in).
  8. Inspect the coil boots for rips, nicks or tears. Remove and discard any damaged coil boots.
    • To install, slide the new coil boot onto the coil until it is fully seated at the top of the coil.
  9. To install, reverse the removal procedure.
    • Apply a small amount of silicone brake caliper grease and dielectric compound to the inside of the ignition coil-on-plug boots before installation.