LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2012 >> E 350 V10-6.8L >> Repair and Diagnosis >> Engine, Cooling and Exhaust >> Engine >> Cylinder Block Assembly >> Engine Block Heater >> Service and Repair

Engine Block Heater: Service and Repair




Block Heater









Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Drain the engine cooling system. For additional information, refer to Cooling System Draining, Filling and Bleeding Cooling System Draining, Filling and Bleeding.

3. NOTICE: Do not loosen the block heater retaining screw more than necessary for removal or damage to the block heater may occur.

Loosen the block heater retaining screw and remove the block heater.
- To install, tighten to 2 Nm (18 lb-in).


4. NOTE: Route the block heater power cable away from hot or rotating components or damage to the cable can occur.

To install, reverse the removal procedure.