LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Focus SES, Standard >> Repair and Diagnosis >> Steering >> Steering Linkage >> Removal And Installation >> Steering Gear Boot >> Removal and Installation

Removal and Installation

NOTE: The steering gear boots and clamps are designed to produce an airtight seal and protect the internal components of the steering gear. If the seal is not airtight, the vacuum generated during turning will draw water and contamination into the gear, causing damage. Zip ties do not provide an airtight seal and must not be used.
NOTE: The inner tie-rod ball joint grease is not compatible with water. Water trapped in the grease will damage the joint.
  1. Remove the outer tie-rod end. For additional information, refer to TIE ROD - OUTER .
  2. Remove the tie-rod jam nut from the inner tie rod.
  3. Remove the steering gear bellows boot.
    1. Remove and discard the clamps.
    2. Disconnect the vent tube.
    3. Remove the boot.
    Fig 1: Removing Steering Gear Bellows Boot
    G06438667Courtesy of FORD MOTOR CO.
  4. NOTE: Make sure the boot is correctly aligned with the vent tube and the raised alignment mark on the steering gear. Incorrect venting may lead to internal steering gear component damage.
    NOTE: Right side shown in the illustration, left side similar.
    NOTE: To prevent the boot from twisting during toe adjustment, apply the specified grease to the groove in the tie rod and uniformly to the inner diameter of the boot.
    NOTE: Make sure the tie rod is clean before installing the boot.

    Position the steering gear bellows boot onto the inner tie rod.

    Fig 2: Positioning Steering Gear Bellows Boot Onto Inner Tie Rod
    G06438668Courtesy of FORD MOTOR CO.
  5. NOTE: Install new inner and outer bellows boot clamps.

    To install, reverse the removal procedure.

    • Use the Boot Clamp Pliers to tighten the new inner bellows boot clamp.
    Fig 3: Tightening Inner Bellows Boot Clamp
    G06256310Courtesy of FORD MOTOR CO.
  6. Check and, if necessary, adjust the front toe. For additional information, refer to SUSPENSION SYSTEM - GENERAL INFORMATION .