LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Focus SES, Automatic >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System >> Removal And Installation >> Power Steering Pump Pulley >> Installation

Power Steering Pump Pulley: Installation

  1. NOTE: Make sure the pulley is flush with the end of the power steering pump shaft.

    Using the Power Steering Pump Pulley Installer, install the power steering pump pulley.

    Fig 1: Installing Power Steering Pump Pulley
    G06438647Courtesy of FORD MOTOR CO.
  2. Position the engine coolant reservoir onto the locating pin and install the 2 bolts.
    • Tighten to 4 Nm (35 lb-in).
  3. Rotate the tensioner clockwise and position the accessory drive belt on the power steering pump pulley.
  4. Position the accessory drive belt splash shield and install the 2 bolts.
    • Tighten to 9 Nm (80 lb-in).