LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2011 >> Edge SE, AWD >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System >> Removal And Installation >> Power Steering Pump >> Removal

Power Steering Pump: Removal

NOTE: While repairing the power steering system, care should be taken to prevent the entry of foreign material or failure of the power steering components may result.
NOTE: Install a new pressure line clamp plate bolt.

All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING
  2. Using a suitable suction device, remove the power steering fluid from the fluid reservoir.
  3. Remove the RH inner fender splash shield. For additional information, refer to FRONT END BODY PANELS
  4. Position the Stretchy Belt Remover on the power steering pump belt as shown in the illustration.
    Fig 1: Positioning Stretchy Belt Remover On Power Steering Pump Pulley Belt
    G07397625Courtesy of FORD MOTOR CO.
  5. NOTE: Feed the Stretchy Belt Remover onto the power steering pump pulley approximately 90 degrees.
    Fig 2: Turning Crankshaft
    G07397626Courtesy of FORD MOTOR CO.
  6. Turn the crankshaft clockwise and feed the Stretchy Belt Remover evenly on the power steering pump pulley as shown in the illustration.
  7. Remove the power steering pump belt.
    • Fold the Stretchy Belt Remover under the inside of the power steering pump belt as shown in the illustration.
    • In one quick motion, firmly pull the Stretchy Belt Remover out through the RH fender well removing the power steering pump belt.
      Fig 3: Removing Power Steering Pump Belt
      G07397627Courtesy of FORD MOTOR CO.

    All-Wheel Drive (AWD) vehicles 

  8. Remove the 4 bolts and position the driveshaft aside.
    Fig 4: Locating Driveshaft Bolts
    G07397628Courtesy of FORD MOTOR CO.

    All vehicles 

  9. Using a suitable jack, support the rear of the subframe.
  10. Remove the 2 nuts, 4 bolts and the subframe support brackets.
    Fig 5: Locating Subframe Support Brackets Bolts And Nuts
    G07397629Courtesy of FORD MOTOR CO.
  11. Remove the 2 middle subframe nuts.
    Fig 6: Locating Middle Subframe Nuts
    G07397630Courtesy of FORD MOTOR CO.
  12. Lower the rear of the subframe.
  13. Release the clamp and disconnect the power steering pump supply hose from the power steering pump.
  14. Remove and discard the pressure line clamp plate bolt and disconnect the pressure line from the pump.
  15. Remove the 3 power steering pump bolts and the pump.