LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2008 >> Ranger 4WD V6-3.0L >> Repair and Diagnosis >> Transmission and Drivetrain >> Transfer Case >> Service and Repair >> Procedures

Procedures

Transfer Case Draining and Filling








1. Remove the drain plug and drain the fluid.
^ Clean and install the drain plug after fluid is drained.
^ Tighten to 24 Nm (18 lb-ft).





2. CAUTION: Incorrect fluid fill may result in transfer case failure.

NOTE: Clean the area around the fill plug.

Remove the fill plug and fill the transfer case.
^ The fluid must be just below the fill plug hole. Because the fluid can be reached with a finger does not mean the fluid is at the correct level. Make sure the fluid is level with the filler opening for the correct fluid level.
^ The total transfer case fill capacity is 1.2L (2.5 pt).





3. Install the fill plug.
^ Tighten to 24 Nm (18 lb-ft).