LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2008 >> Ranger 4WD V6-3.0L >> Repair and Diagnosis >> Heating and Air Conditioning >> Blower Motor >> Service and Repair

Blower Motor: Service and Repair

BLOWER MOTOR







Removal and Installation
1. Disconnect the speed control actuator electrical connector.
2. Remove the speed control actuator bolt and position the speed control actuator aside.
- To install, tighten to 11 Nm (8 lb-ft).

3. Disconnect the blower motor electrical connector.
4. Remove the blower motor vent tube.
5. Remove the 4 blower motor screws and the blower motor.
6. Remove the blower motor wheel clip.
7. Remove the blower motor wheel.
8. To install, reverse the removal procedure.