LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2008 >> F 150 2WD V6-4.2L >> Repair and Diagnosis >> Powertrain Management >> Computers and Control Systems >> Oxygen Sensor >> Service and Repair >> Heated Oxygen Sensor (HO2S)

Heated Oxygen Sensor (HO2S)

HEATED OXYGEN SENSOR (HO2S)


RH Inner Fender Splash Shield:






Heated Oxygen Sensors (HO2S) And Catalyst Monitor Sensors:






Exploded View


Special Tool(s):






Special Tool(s)

Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist.
2. If necessary, detach the electrical connector from the RH inner fender splash shield.
3. If necessary, remove the 6 screws, the pushpin and the RH inner fender splash shield.
4. Disconnect the heated oxygen sensor (HO2S) electrical connector.







5. NOTE: If necessary, lubricate the HO2S with lock lubricant to assist in removal.

Using the special tool, remove the HO2S.
- To install, tighten to 46 Nm (34 lb-ft).

6. NOTE: Apply anti-seize to the threads of the HO2S.

To install, reverse the removal procedure.