LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Expedition RWD >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System >> Removal And Installation >> Steering Gear >> Removal

Steering Gear: Removal

CAUTION: While repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of the power steering components can result.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. CAUTION: Do not allow the steering column shaft to rotate while disconnected from the gear or damage to the clockspring can occur. if there is evidence that the steering column shaft has rotated, the clockspring must be recentered. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM article.
  3. Hold the steering wheel in the straight ahead position using a suitable holding device.
  4. Fig 1: Holding Steering Wheel Straight Ahead
    GF0023028Courtesy of FORD MOTOR CO.
  5. Remove and discard the outer tie-rod end nuts.
  6. CAUTION: Do not damage the tie-rod boot when installing the special tool.
  7. Using the special tool, disconnect the tie-rod ends from the wheel knuckles.
  8. Fig 2: Separating Tie-Rod End From Wheel Knuckle
    GF0022168Courtesy of FORD MOTOR CO.
  9. Release the lower cooling fan shroud tab and rotate the shroud upward.
  10. Fig 3: Cooling Fan Shroud Lower Lock Tab
    GF0022013Courtesy of FORD MOTOR CO.
  11. Remove the 2 bolts and the oil drip shield.
  12. Fig 4: Locating Oil Drip Shield Bolts
    GF0004275Courtesy of FORD MOTOR CO.
    CAUTION: Do not allow the steering column shaft to rotate while it is disconnected from the steering gear or damage to the clockspring can result. If there is evidence that the steering column shaft has rotated, the clockspring must be removed and recentered. For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM article.
  13. Remove the steering column shaft-to-steering gear bolt and disconnect the steering column shaft from the steering gear.
  14. CAUTION: New O-ring seals must be installed any time the lines are disconnected from the steering gear or a fluid leak may occur.
  15. Remove the power steering line clamp plate bolt, rotate the clamp plate and disconnect the power steering lines.
    • Discard the O-ring seals.
  16. Remove the 2 steering gear-to-crossmember bolts and remove the steering gear.
    • Discard the bolts.