LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Expedition RWD >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System >> Removal And Installation >> Power Steering Pump >> Removal And Installation

Removal And Installation

CAUTION: While repairing the power steering system, care should be taken to prevent the entry of contaminants or premature failure of the power steering components can result.
NOTE: A new Teflon® seal must be installed any time the line is disconnected from the power steering pump.
  1. Remove the power steering pump pulley. For additional information, refer to Power Steering Pump Pulley .
  2. Release the clamp and disconnect the power steering fluid reservoir-to-pump supply hose.
  3. Remove the power steering pressure line bracket-to-engine nut.
    • To install, tighten to 40 Nm (30 lb-ft).
  4. Fig 1: Power Steering Pressure Line Bracket-To-Engine Nut
    GF0023021Courtesy of FORD MOTOR CO.
  5. Disconnect the power steering pressure line-to-power steering pump fitting.
    • Discard the Teflon® seal.
    • To install, tighten to 65 Nm (48 lb-ft).
  6. Remove the 3 bolts and the power steering pump.
    • To install, tighten to 25 Nm (18 lb-ft).
  7. To install, reverse the removal procedure.
    • Using the special tool, install a new Teflon® seal on the pressure line-to-pump fitting.
  8. Fig 2: Installing Teflon(R) Seal Using Special Tool
    G03950191Courtesy of FORD MOTOR CO.
  9. Fill the power steering system. For additional information, refer to STEERING SYSTEM - GENERAL INFORMATION article.