LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2007 >> Expedition RWD >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System >> Removal And Installation >> Inner Tie Rod >> Removal

Inner Tie Rod: Removal

CAUTION: The steering gear bellows boots and clamps are designed to provide an airtight seal and protect the internal components of the steering gear. If the seal is not airtight, the vacuum generated during turning will draw water and contamination into the gear, causing premature damage.
CAUTION: Zip ties do not produce an airtight seal and must not be used.
CAUTION: The inner tie-rod ball joint grease is not compatible with water. Contamination trapped in the grease will degrade the life of the joint.
CAUTION: If present, the orientation of the vent tube must be noted so the boots and vent tubes can be installed in the correct location.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Loosen the tie-rod end jam nut.
  3. Remove and discard the outer tie-rod end nut.
  4. CAUTION: Be careful not to damage the tie-rod boot when installing the special tool.
  5. Using the special tool, disconnect the tie-rod end from the wheel knuckle.
  6. Fig 1: Separating Tie-Rod End From Wheel Knuckle
    GF0022168Courtesy of FORD MOTOR CO.
    NOTE: Count the number of turns required to remove the tie-rod end for reference during installation.
  7. Remove the outer tie-rod end.
  8. Remove the tie-rod end jam nut.
  9. NOTE: New bellows boot clamps must be installed.
  10. Remove and discard the inner and outer bellows boot clamp.
  11. Remove the steering gear bellows boot.
  12. NOTE: Place the steering gear at the center position. Use a 1-1/16 inch crowfoot on the flat of the rack gear to resist rotation and to prevent damage during removal and installation of the inner tie rod.
    NOTE: If repairing the RH side, it will be necessary to pull back the LH inner tie-rod boot to hold the steering gear.
    NOTE: An assistant may be needed for removal of the RH inner tie rod.
  13. Using the special tool, remove the inner tie rod.
  14. Fig 2: Identifying Special Tool & Inner Tie-Rod
    GF0017911Courtesy of FORD MOTOR CO.
    CAUTION: Thoroughly remove any abrasive material. This material is extremely harmful to the steering gear.
  15. Thoroughly clean and inspect all the parts to be reused. Install new parts as necessary.