LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2005 >> Crown Victoria Base, 4.6 W >> Repair and Diagnosis >> Body & Frame >> Seats >> Seat System >> Removal And Installation >> Lumbar Control Switch >> Removal

Lumbar Control Switch: Removal

WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag module. This will reduce the risk of injury in the event of an accidental deployment.
WARNING: Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
WARNING: To reduce the risk of personal injury, do not use any memory saver devices.
NOTE: If a seat equipped with a supplemental restraint system (SRS) component is being serviced, the SRS must be depowered. 
NOTE: The air bag warning lamp illuminates when the RCM fuse is removed and the ignition switch is ON. This is normal operation and does not indicate a supplemental restraint system (SRS) fault.
NOTE: The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
NOTE: Driver side shown, passenger side similar.
  1. Depower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .
  2. NOTE: Take care in removing the power lumbar bezel, pry the side of bezel at tabs to remove.
    Fig 1: Removing Power Lumbar Cover
    G03880363Courtesy of FORD MOTOR CO.
  3. Remove the cover.
  4. Disconnect the lumbar control switch electrical connector. Remove the lumbar control switch.
    Fig 2: Disconnecting Lumbar Control Switch Electrical Connector
    G03880364Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
  6. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .