Front Seat Backrest: Assembly
- Slide the lumbar support bracket and lumbar assembly on lumbar seat frame until seated on the two clips.
- Install the lumbar motor and attach the lumbar motor bracket clip.
- Attach the trim cover to the backrest foam pad.
- Align the backrest foam pad and trim cover to the backrest frame.
- Install the head restraint sleeves.
- Install the head restraint locking clip onto the head restraint sleeve.
- If necessary, route the side air bag wire harness and install the pin-type retainers to the backrest frame as noted during disassembly.
- Position the deployment chute through the outboard slot in the backrest foam pad.
- Connect the side air bag module electrical connector.
- Position the side air bag module into the deployment chute.
- Position the side air bag module into the deployment chute with the alignment pin offset to the top and the electrical connector to the bottom of the seat back. This will position the alignment pin correctly when the side air bag module and deployment chute are mounted to the seat back frame mounting bracket.
- The side air bag module mounting studs and alignment pin must come through the deployment chute stud openings.
- Install the side air bag module onto the front seat back frame mounting bracket. Install the nuts.
- The deployment chute should not have any wrinkles or folds where it contacts the seat back frame mounting bracket.
- Reposition the seat back pad and trim cover to the seat back frame.
- Install the inboard hog rings that attach the foam pad to the seat backrest frame.
- Make sure the hog rings go around the listing wire in the foam pad as well as the backrest frame wire.
- Install the head restraint.
- Install the front seat backrest. For additional information, refer to FRONT SEAT BACKREST .
- Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering in the General Procedures portion of SUPPLEMENTAL RESTRAINT SYSTEM .
Vehicles With Power Lumbar
All Vehicles
Police Vehicles
Vehicles With Seat Side Air Bags
WARNING:
Inspect the mounting surfaces of the side air bag module for any foreign objects before installing the side air bag module. If any foreign objects are found, remove them. Failure to do so may result in personal injury, in the event of an air bag deployment.
WARNING:
Inspect the side air bag deployment chute and the side air bag cavity in the seat back pad for any foreign objects. If any foreign objects are found, remove them. Failure to do so may result in personal injury, in the event of an air bag deployment.
WARNING:
Before installing the side air bag module into the deployment chute, check it for damage and foreign objects. If the air bag module is damaged, replace it. If any foreign objects are found, remove them. Failure to do so may result in personal injury, in the event of an air bag deployment.
WARNING:
If the air bag cover has separated or the air bag material has been exposed, install a new side air bag module. Do not attempt to repair the air bag module. Failure to do so may result in personal injury, in the event of an air bag deployment.
WARNING:
Check the side air bag deployment chute for damage. The deployment chute must not be repaired. If there is any damage to the deployment chute, the seat back trim cover and deployment chute must be installed new as a unit.
WARNING:
If the air bag deployment chute is not properly positioned, the side air bag may not deploy properly.
NOTE:
The alignment pin will only allow the side air bag module to be installed to the seat back mounting bracket one way.
WARNING:
Inspect the mounting surfaces of the side air bag module and the seat back frame mounting bracket for any foreign objects before installing the side air bag module. If any foreign objects are found, remove them. Failure to do so can result in personal injury in the event of an air bag deployment.
All Vehicles