Removal and Installation
WARNING: This page is about a different car, the 2003 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the steering wheel to the straight-ahead position and turn the ignition switch to the OFF position.
- Remove the left front wheel and tire assembly. For additional information, refer to WHEELS & TIRES .
- While holding the intermediate shaft dash panel seal out of the way, remove and discard the pinch bolt and disconnect the coupler.
- Lower the vehicle.
- Remove and discard the upper and lower steering column shaft pinch bolts and remove the coupler.
- Remove the three retaining nuts and remove the intermediate shaft and seal.
- To install, reverse the removal procedure.
CAUTION:
Do not allow the steering wheel to rotate while the steering column intermediate shaft is disconnected or damage to the clockspring can result. If there is evidence that the steering column shaft has rotated, the clockspring must be removed and recentered.
.
NOTE:
Discard the upper and lower intermediate shaft-to-steering column shaft pinch bolts upon removal. Do not reuse; install new bolts.
CAUTION:
Do not allow the steering wheel to rotate while the steering column intermediate shaft is disconnected or damage to the clockspring can result. If there is evidence that the intermediate shaft has rotated, the clockspring must be removed and recentered. For additional information, refer to AIR BAG RESTRAINT SYSTEMS
.