LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Mustang Mach 1, Standard >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> Engine System-General Information >> General Procedures >> Connecting Rod - Bearing Journal Clearance

Connecting Rod - Bearing Journal Clearance

Fig 1: Identifying Special Tool
G01623442Courtesy of FORD MOTOR CO.
NOTE: The crankshaft connecting rod journals must be within specifications to check the connecting rod bearing journal clearance.
  1. Remove the connecting rod bearing cap.
  2. Position a piece of Plastigage across the bearing surface.
    Fig 2: Locating Bearing Surface
    G01623443Courtesy of FORD MOTOR CO.
  3. NOTE: Do not turn the crankshaft during this step.
  4. Install and tighten to specifications, then remove the connecting rod bearing cap.
  5. Measure the Plastigage to get the connecting rod bearing journal clearance. The Plastigage should be smooth and flat. A changing width indicates a tapered or damaged connecting rod or connecting rod bearing.
    • Refer to the appropriate ENGINE article for the procedure.
    • If out of specification, install new components as necessary. Refer to the appropriate ENGINE article for the procedure.
    Fig 3: Measuring Connecting Rod Bearing Journal Clearance
    G01623444Courtesy of FORD MOTOR CO.