LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2003 >> Mustang Mach 1, Automatic >> Repair and Diagnosis >> Steering >> Power Steering >> Power Steering System >> Removal And Installation >> Gear >> Removal

Removal And Installation: Gear: Removal

  1. Turn the steering wheel as necessary to position the wheels in the straight-ahead position. Do not lock the steering column.
  2. Raise and support the vehicle.
  3. Remove the front wheels and tires. For additional information, refer to WHEELS & TIRES .
  4. Remove the cotter pin and nut. Discard the cotter pin.
    Fig 1: Removing Cotter Pin And Nut
    G01623242Courtesy of FORD MOTOR CO.
  5. Using the special tool, disconnect the tie-rod end.
    Fig 2: Disconnecting Tie-Rod End
    G01623243Courtesy of FORD MOTOR CO.
  6. Rotate the steering column intermediate shaft as necessary access the pinch bolt. Remove and discard the pinch bolt.
    Fig 3: Removing And Discard Pinch Bolt
    G01623244Courtesy of FORD MOTOR CO.
  7. Lower the vehicle.
  8. Turn the steering wheel back to the straight-ahead position. Turn the ignition key to the locked position.
  9. CAUTION: Do not rotate the steering wheel when the lower steering column shaft is disconnected, or damage to the air bag sliding contact will result.
    Fig 4: Disconnecting Steering Column Intermediate Shaft Coupling
    G01623245Courtesy of FORD MOTOR CO.
  10. Disconnect the steering column intermediate shaft coupling (3A525).
  11. Remove the nuts, washers and bolts. Position the steering gear (3504) forward.
    Fig 5: Removing Nuts, Washers And Bolts
    G01623246Courtesy of FORD MOTOR CO.
  12. Disconnect the power steering hoses. Remove and discard the seal rings.
    • Plug or cap the power steering hoses and steering gear ports to prevent damage and the entry of foreign material.
    Fig 6: Disconnecting Power Steering Hoses
    G01623247Courtesy of FORD MOTOR CO.
  13. Remove the steering gear.