LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Taurus SES, 3.0 2, AX4S >> Repair and Diagnosis >> Steering >> Steering Column >> Removal And Installation >> Steering Column Shaft-Intermediate >> Removal and Installation

Removal and Installation

  1. Turn the steering wheel to the straight ahead position and turn the ignition switch to the OFF position.
  2. CAUTION: Do not allow the steering wheel to rotate while the steering column intermediate shaft is disconnected or damage to the clockspring can result. If there is evidence that the intermediate shaft has rotated, the clockspring must be removed and recentered. Refer to CLOCKSPRING CENTERING .
    Fig 1: Removing Lower Coupling Pinch Bolt
    G02156589Courtesy of FORD MOTOR CO.
  3. Remove the lower coupling pinch bolt and disconnect the intermediate shaft from the coupling.
    • Discard the bolt.
  4. Remove the three retaining nuts and remove the intermediate shaft and seal.
    Fig 2: Removing Intermediate Shaft & Seal
    G02156590Courtesy of FORD MOTOR CO.
  5. Remove the pinch bolt and remove the intermediate shaft.
    • Discard the bolt.
    Fig 3: Removing Pinch Bolt & Removing Intermediate Shaft
    G02156591Courtesy of FORD MOTOR CO.
  6. To install, reverse the removal procedure.