LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Explorer 4.0 K, RWD, Automatic >> Repair and Diagnosis >> Steering >> Steering Column >> Removal And Installation >> Ignition Switch Lock Cylinder - Non-Functional >> Removal and Installation

Removal and Installation

  1. Disconnect the battery ground cable and wait at least one minute. For additional information, refer to BATTERY, MOUNTING & CABLES .
  2. Remove the screws and the instrument panel steering column cover.
    Fig 1: Removing Screws And Instrument Panel Steering Column Cover
    G02167358Courtesy of FORD MOTOR CO.
  3. CAUTION: Do not use a prying device to detach the shift lever boot or damage to the shrouds may result.
    Fig 2: Detaching Boot From Shrouds
    G02167359Courtesy of FORD MOTOR CO.
  4. Detach the boot from the shrouds.
  5. Remove the screws and the steering column lower shroud.
    Fig 3: Removing Screws And Steering Column Lower Shroud
    G02167360Courtesy of FORD MOTOR CO.
  6. Disconnect the electrical connector.
    Fig 4: Disconnecting Electrical Connector
    G02167361Courtesy of FORD MOTOR CO.
  7. Remove the screw and the PATS transceiver.
    Fig 5: Removing Screw And PATS Transceiver
    G02167362Courtesy of FORD MOTOR CO.
  8. CAUTION: Do not allow the drill bit to make contact with the column housing or damage to the housing will result. If there is damage to the housing a new column must be installed.
  9. Use a 3/16-inch diameter drill bit to drill out the lock cylinder retaining pin and remove the ignition switch lock cylinder.
    • Discard the lock cylinder.
    • Remove the drill shavings from the steering column (3C529).
      Fig 6: Drilling Out Lock Cylinder Retaining Pin And Removing Ignition Switch Lock Cylinder
      G02167363Courtesy of FORD MOTOR CO.
  10. To install, reverse the removal procedure.
    • Verify the ignition switch lock cylinder operation.