LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2002 >> Explorer 4.0 K, RWD, Automatic >> Repair and Diagnosis >> Steering >> Steering Column >> Removal And Installation >> Ignition Switch Lock Cylinder - Functional >> Removal and Installation

Removal and Installation

  1. Disconnect the battery ground cable and wait at least one minute. For additional information, refer to BATTERY, MOUNTING & CABLES .
  2. Remove the screws and the instrument panel steering column cover.
    Fig 1: Removing Screws And Instrument Panel Steering Column Cover
    G02167352Courtesy of FORD MOTOR CO.
  3. CAUTION: Do not use a prying device to detach the shift lever boot or damage to the shrouds may result.
    Fig 2: Detaching Boot From Shrouds
    G02167353Courtesy of FORD MOTOR CO.
  4. Detach the boot from the shrouds.
  5. Remove the screws and the steering column shrouds.
    Fig 3: Removing Screws And Steering Column Shrouds
    G02167354Courtesy of FORD MOTOR CO.
  6. Disconnect the electrical connector.
    Fig 4: Disconnecting Electrical Connector
    G02167355Courtesy of FORD MOTOR CO.
  7. Remove the screw and the PATS transceiver.
    Fig 5: Removing Screw And PATS Transceiver
    G02167356Courtesy of FORD MOTOR CO.
  8. With the key in the ACCESSORY position, depress the ignition lock cylinder release pin and remove the lock cylinder.
    Fig 6: Depressing Ignition Lock Cylinder Release Pin And Removing Lock Cylinder
    G02167357Courtesy of FORD MOTOR CO.
  9. To install, reverse the removal procedure.
    • Verify the ignition switch lock cylinder operation.