LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2001 >> Focus S2 >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission Overhaul >> Performance Tests >> Air Pressure Tests

Air Pressure Tests

WARNING: Use only dry, regulated air pressure at 40 psi (2.8 kg/cm ) maximum.
NOTE: Air pressure tests substitute air pressure for fluid pressure to aid in determining the location of transaxle component failure.
  1. Drain transaxle fluid and remove transaxle oil pan. Remove valve body. See VALVE BODY ASSEMBLY  under REMOVAL & INSTALLATION. Install transaxle Pressure Test Plate and Gasket (307-412). Use oil pan bolts to secure test plate. Tighten bolts to 89 INCH lbs. (10 N.m).
  2. Apply air pressure to appropriate clutch port(s). See Fig 1 . A dull thud should be felt or heard or movement can be observed when component applies. If a hissing sound is heard with component fully applied, clutch seals or check balls are leaking.
    Fig 1: Identifying Transaxle Pressure Test Plate Ports
    G00022511Courtesy of FORD MOTOR CO.
  3. If air pressure test results reveal that servos do not operate, disassemble, clean and inspect servos to locate source of failure. If air pressure applied to clutch ports fails to operate a clutch or operates another clutch simultaneously, disassemble and use air pressure to check fluid passages in transaxle case and clutches to detect obstruction(s).