LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2001 >> Crown Victoria Base, 4.6 W >> Repair and Diagnosis >> Electrical >> Gauges >> Instrument Panels - Analog >> System Tests >> Test At: Key-In-Ignition Chime Does Not Operate Properly

Test At: Key-In-Ignition Chime Does Not Operate Properly

  1. Ensure all doors are closed. Turn ignition switch to LOCK position. Connect NGS/WDS tester. Turn ignition switch to ON position. Ensure no new warnings are displayed on instrument cluster. Using NGS/WDS tester, perform self-test. If DTC B1352 exists, go to next step. If DTC B1352 does not exist, system is okay.
  2. Turn ignition switch to LOCK position. Using NGS/WDS tester, monitor Lighting Control Module (LCM) PID IGN_KEY. If PID is not IN, go to next step. If PID is IN, replace LCM.
  3. Disconnect 16-pin LCM connector C2027. Measure resistance between ground and LCM harness connector C2027 terminal No. 3 (Black/Pink wire). If resistance is 5 ohms or more, go to next step. If resistance is less than 5 ohms, replace LCM.
  4. Disconnect pin key-in-ignition switch connector C283. Measure resistance in Black/Pink wire between LCM harness connector C2027 terminal No. 3 and headlight switch harness connector C283 terminal.