Test D: Trunk Lid Inoperative
- If DTC B1553 was retrieved, go to next step. If DTC B1553 was not retrieved, go to step 3 .
- Disconnect 18-pin Driver Door Module (DDM) harness connector C519. DDM is located in driver's door. Turn ignition switch to ON position. Measure voltage between ground and DDM harness connector C519 terminal No. 13 (White/Violet wire). See Figure . If voltage does not exist, go to step 9 . If voltage exists, repair short to voltage on White/Violet wire between DDM and trunk lid release switch harness connector C501 terminal No. 1.
- Disconnect 18-pin Driver Door Module (DDM) harness connector C519. DDM is located in driver's door. Measure resistance between ground and DDM harness connector C519 terminal No. 13 (White/Violet wire) while depressing trunk lid release switch. See Figure . If resistance is 5 ohms or more, go to next step. If resistance is less than 5 ohms, go to step 6 .
- Disconnect 2-pin trunk lid release switch harness connector C501. Measure resistance of White/Violet wire between DDM harness connector C519 terminal No. 13 and trunk lid release switch harness connector C501 terminal No. 1. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open on White/Violet wire between DDM and trunk lid release switch harness connector C501 terminal No. 1.
- Measure resistance between ground and trunk lid release switch harness connector C501 terminal No. 2 (Black wire). If resistance is less than 5 ohms, replace trunk lid release switch. If resistance is 5 ohms or more, repair open on Black wire.
- Using a fused jumper wire, momentarily connect battery positive to DDM harness connector C519 terminal No. 7 (Violet/Yellow wire). If trunk lid does not open, go to next step. If trunk lid opens, go to step 9 .
- Disconnect 3-pin trunk lid release solenoid harness connector C478. Measure resistance of Violet/Yellow wire between DDM harness connector terminal No. 7 and trunk lid release solenoid harness connector C478 terminal No. 2. If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open on Violet/Yellow wire.
- Measure resistance between ground and trunk lid release solenoid harness connector C478 terminal No. 2 (Black wire). If resistance is less than 5 ohms, replace trunk lid release solenoid. If resistance is 5 ohms or more, repair open on Black wire between trunk lid release solenoid and ground point, located on right kick panel.
- Disconnect all DDM harness connectors. Check all harness connector and DDM harness connectors and terminals. Repair as necessary. Connect all harness connectors. Operate system. If problem still exists, replace DDM. If problem does not exist, test is complete.