LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> ZX2 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 509 (Cruise Control System) >> Diagnosis And Testing >> Speed Control >> Pinpoint Test D: The Set Speed Fluctuates >> Pinpoint Test D: The Set Speed Fluctuates

Pinpoint Test D: The Set Speed Fluctuates

WARNING: This page is about a different car, the 2004 Mercury Monterey and 2004 Ford Freestar. However, it is still accessible from the selected car via links, so may be relevant.
  1. D1 CHECK THE SPEED CONTROL THROTTLE ATTACHMENT 
    NOTE: There must not be any loose components when carrying out the speed control actuator slack test.
    • Check the throttle lever, speed control cable, and accelerator cable bracket for correct operation while carrying out the speed control actuator slack test on the diagnostic tool.
    • Do the throttle lever components operate correctly? 

    Yes 

    The system is operating correctly at this time. CLEAR the DTCs. REPEAT the self-test.

    No 

    GO to D2.

  2. D2 CHECK FOR CORRECT SPEED CONTROL ACTUATOR OPERATION 
    • Disconnect the speed control actuator connector.
    • Check for:
      • corrosion
      • pushed-out pins
    • Connect the speed control actuator connector and make sure it seats correctly.
    • Operate the system and verify the concern is still present.
    • Is the concern still present? 

    Yes 

    INSTALL a new speed control actuator. Refer to SPEED CONTROL ACTUATOR . CLEAR the DTCs. REPEAT the self-test.

    No 

    The system is operating correctly at this time. Concern may have been caused by a loose or corroded connector. CLEAR the DTCs. REPEAT the self-test.