LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Focus ZX3, Standard >> Repair and Diagnosis (Single Page) >> Restraints >> Air Bag, SRS >> Supplemental Inflatable Restraint System >> Removal & Installation >> Restraints Control Module >> Removal & Installation

Removal & Installation

  1. Before proceeding, See AIR BAG SAFETY PRECAUTIONS . Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Remove center console front cup holder inserts (one on each side). Remove screw located underneath each cup holder insert. Remove cup holder insert from center console rear cup holder.
  2. Remove 3 nuts located underneath cup holder insert. Detach hand brake lever and shift lever boots from center console. Remove hand brake lever boot. Fully raise hand brake lever. Lift up on rear of center console and remove console from vehicle.
  3. Depress RCM harness connector locking tang, slide locking bar back and disconnect connector from RCM. Remove 3 RCM mounting bolts and remove RCM from vehicle.
  4. To install, reverse removal procedure. Tighten RCM mounting bolts to specification. See TORQUE SPECIFICATIONS . Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM. Ensure air bag system is functioning properly. See SYSTEM OPERATION CHECK .