Test A: No Scan Tool Communication With Gem
NOTE:
After repair, clear DTCs and retest system.
- Turn ignition switch to LOCK position. Connect New Generation Star (NGS) tester to Data Link Connector (DLC). DLC is located below center of instrument panel. Using NGS tester, observe Generic Electronic Module (GEM) PIDs IGN_A, IGN_R, IGN_S and IGN_O/L while turning ignition switch through all positions. If PID values agree with ignition switch positions, go to next step. If PID values do not agree with ignition switch positions, repair appropriate ignition switch circuit(s). See appropriate wiring diagram in POWER DISTRIBUTION article in WIRING DIAGRAMS.
- Turn ignition switch to LOCK position. Disconnect central junction box 34-pin connector C243. Measure voltage between connector C243 terminal No. 11 (Tan/Black wire) and ground. See Fig 1 . If voltage is more than 10 volts, go to next step. If voltage is 10 volts or less, repair Tan/Black wire.
- Disconnect GEM from central junction box 18-pin connector C267. Connect central junction box connector C243. Measure voltage between central junction box connector C267 terminal No. 4 (central junction box side) and ground. Measure voltage between connector C267 terminal No. 16 (central junction box side) and ground. See Fig 1 . If voltages are more than 10 volts, go to next step. If voltages are 10 volts or less, replace central junction box.
- Disconnect GEM 26-pin connector C239. Measure resistance between GEM connector C239 terminal No. 26 (Black/Light Blue wire) and ground. See Fig 2 . If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open in Black/Light Blue wire.
- Measure resistance between GEM connector C239 terminal No. 14 (Black/Light Blue wire) and ground. If resistance is less than 5 ohms, repair module communications concern. See MODULE COMMUNICATIONS NETWORK - EXPEDITION & NAVIGATOR article. If resistance is 5 ohms or more, repair open in Black/Light Blue wire.