LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1999 >> Expedition 5.4 L, 4WD >> Repair and Diagnosis >> Accessories & Equipment >> Communication Devices >> Module Communications Network >> System Tests >> Test C: Generic Electronic Module (Gem) Does Not Respond To NGS Tester

Test C: Generic Electronic Module (Gem) Does Not Respond To NGS Tester

NOTE: After making any repair, perform data link diagnostic procedure. See DATA LINK DIAGNOSTIC TEST  under SELF-DIAGNOSTIC SYSTEM.
  1. Turn ignition switch to LOCK position. Disconnect Generic Electronic Module (GEM) Gray 26-pin connector. See Figure. Inspect connector GEM connector for loose, damaged or corroded terminals. Repair as necessary. If connector is okay, go to next step.
  2. Measure resistance of Light Blue/White wire between GEM 26-pin connector terminal No. 25 and DLC terminal No. 7. See Figure and Figure . If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open in Light Blue/White wire between GEM 26-pin connector and DLC.
  3. Connect GEM 26-pin connector. Perform data link diagnostic procedure. See DATA LINK DIAGNOSTIC TEST  under SELF-DIAGNOSTIC SYSTEM. If GEM responds to NGS tester, system is functioning properly. If GEM does not respond to NGS tester, replace GEM. See GENERIC ELECTRONIC MODULE/CENTRAL TIMER MODULE (GEM/CTM) under REMOVAL & INSTALLATION in ANALOG INSTRUMENT PANEL - EXPEDITION, F150 & F250 LIGHT-DUTY PICKUPS, & NAVIGATOR article.