LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1998 >> Mustang Cobra, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 11 (Engine Controls - Remove/Install/Overhaul - 3.8L) >> Fuel System >> Upper Intake Manifold >> Installation

Upper Intake Manifold: Installation

WARNING: This page is about a different variant/trim than selected.

Place NEW gasket on lower intake manifold locating pins. Install upper intake manifold and tighten bolts in sequence to specification. See Fig 1. To complete installation, reverse removal procedure.

Fig 1: Upper Intake Manifold Tightening Sequence
G95B27921Courtesy of FORD MOTOR CO.