LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1998 >> Explorer 4D Utility, 4.0 X, AWD >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> System Testing >> Test D: Flash Code 4 - Vehicle Speed Sensor (VSS) Circuit Failure

Test D: Flash Code 4 - Vehicle Speed Sensor (VSS) Circuit Failure

  1. Check Speedometer Operation  - Test drive vehicle and while observing speedometer operation. If speedometer operates properly, go to next step. If speedometer does not operate properly, see appropriate INSTRUMENT PANEL article to continue diagnosis.
  2. Check Gray/Black Wire For Open  - Turn ignition off. Disconnect speed control servo/actuator connector C171 (located near right front fenderwell). Disconnect ABS control module connector C186 (located near front fenderwell). Using an ohmmeter, check resistance in Gray/Black wire between speed control servo/actuator connector C171 terminal No. 3 and ABS control module connector C186 terminal No. 10. See Figure and Fig 1 . If resistance is less than 5 ohms, replace speed control servo/actuator and perform SELF-DIAGNOSTIC TEST. If resistance is 5 ohms or more, repair open in Gray/Black wire and perform SELF-DIAGNOSTIC TEST.
Fig 1: Identifying ABS Control Module Connector C186 Terminals
G98H01442Courtesy of FORD MOTOR CO.