DTC B1485 - Brake Pedal Input Circuit Battery Short
- Connect New Generation Star (NGS) Tester (007-00500) to Data Link Connector (DLC). DLC is located at instrument panel, below steering column.
- Go to PID Data Monitor and record. Select RAP PID BOO_RAP. Press brake pedal while monitoring PID. If PID BOO_RAP reads ON then OFF, clear DTCs and repeat On-Demand Self-Test. See MODULE COMMUNICATIONS NETWORK article. If PID BOO_RAP does not read ON then OFF, go to next step.
- Disconnect Remote Anti-theft Personality (RAP) module connector C253. Measure voltage at RAP module connector C253, terminal No. 26 (Red/Light Green wire). See Figure . If less than 10 volts exist, go to next step. If 10 volts or more exist, replace RAP module and retest system.
- Press and hold brake pedal. If brakelights come on, repair open in Red/Light Green wire. If brakelights do not come on, see wiring diagram in EXTERIOR LIGHTS article. Repair wiring as necessary.