LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1995 >> Crown Victoria Base >> Repair and Diagnosis >> Steering >> Power Steering >> Steering System >> Removal & Installation >> Tie Rod Ends >> Installation

Tie Rod Ends: Installation

  1. Apply penetrating oil to clamps, tie rod threads and adjusting sleeves. Wipe threads clean. Lubricate threads with chassis lube. Install adjusting sleeve clamps. Thread tie rod ends same number of turns required during removal.
  2. Ensure both ends are equal distance (within 3 threads) into sleeve. Install castle nuts, using NEW cotter pins. Properly position adjusting sleeve clamps. Lower vehicle and adjust toe-in. See appropriate WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES article in the WHEEL ALIGNMENT section:

WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES - Crown Victoria

WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES - Town Car

WHEEL ALIGNMENT SPECIFICATIONS & PROCEDURES - Grand Marquis

Tighten tie rod end clamp nuts to specification. See TORQUE SPECIFICATIONS  .