LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1995 >> Contour LX, 2.5 L, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - System/Component Tests - EEC-IV (2.5L) >> Ignition System >> EI System (High Data Rate) >> Diagnostic Aids

Diagnostic Aids

Circuits are identified in all capital letters (acronyms). For example, Profile Ignition Pickup is identified as PIP.

Manufacturer's breakout box overlay test terminals are identified by a "J" prefix. For example, J31 (PIP). The J31 indicates that the measurement is to be taken at terminal No. 31 at the breakout box. The (PIP) indicates that the Profile Ignition Pickup circuit is being checked.

When the letter "I" follows the circuit identification, it implies that the measurement is being taken at the ICM. For example, J31 (PIP I). The (PIP I) implies that the measurement is of the PIP circuit at the ICM.

When the letter "S" follows the circuit identification, it implies that the measurement is being taken at the Crankshaft Position Sensor (CKP). For example, J32 (CKP+ S). The (CKP+ S) implies that the measurement is of the CKP sensor positive circuit at the CKP sensor.

When the letter "C" follows the circuit identification, it implies that the measurement is being taken at the coil. For example, J10 (C3C). The (C3C) implies that the measurement is of the C3 circuit at the coil pack.

The following information should also be noted during testing:

NOTE: A 12-volt incandescent (high voltage) test light should not be used to test circuit signals. It will load circuit and may cause incorrect measurements or faulty EI/PCM operation (engine stall).
EI PINPOINT TEST INDEX

Result Pinpoint Test/Step
No Start 
No Codes A/1
PASS Code 111 A/1
Code 212 Or 226 (IDM Signal At PCM Fault) A/1
Code 211 (PIP Signal At PCM Fault) A/1
Malfunction Indicator Light (MIL) On During Cranking A/1
Engine Runs 
Code 212 Or 226 (IDM Signal Fault At PCM) B/1
Code 213 (SPOUT Circuit Fault) C/1
Code 215, 216, 217 And/Or 232 (Coil 1, 2 Or 3 Fault) D/1
Lack Of Power Or Poor Fuel Economy C/1
NOTE: Steps in pinpoint tests are designed to correct one ignition failure at a time. When a component is replaced or service is completed, remove all test equipment. Reconnect all components, and perform QUICK TEST. See the appropriate TESTS W/CODES - EEC-IV (2.5L) article.
WARNING: DO NOT connect PCM to EI diagnostic cable; 60-pin connector on this harness may be connected to a breakout box only. If PCM is connected to EI diagnostic cable, PCM may be damaged. Some tests may require a second breakout box to be connected to PCM 60-pin connector. When a second breakout box is used, PCM should be disconnected at all times. Never connect PCM to breakout box when performing EI diagnostics.
Fig 1: EI Diagnostic Cable Diagram
G93H41480
Fig 2: EI Wiring Diagram
G93I41481
Fig 3: EI System Pin Voltage Chart
G93J41482
Fig 4: EI Signal Diagram
G93A41483
Fig 5: EI Block Diagram
G93B41484