Diagnostic Aids
Code 42 or 92 may be caused by fuel-contaminated engine oil, ignition misfire, or EGR system or CANP problems. If oil is suspect, remove PCV valve from valve cover and repeat QUICK TEST. If problem is corrected, change engine oil.
On CIRCUIT TEST H and CIRCUIT TEST J, vacuum leaks in non-EEC related areas may cause Code 41 or 91 to be displayed. Check vacuum motors, engine seals, EGR system, PCV system, Canister Purge (CANP), HEGO sensor, and between airflow meter and throttle body for unmetered air leaks.
NOTE:
In following tests, circuit diagrams and illustrations are courtesy of Ford Motor Co.
CIRCUIT TESTS are grouped as follows.
- A-C - No Start & Voltage Tests
- DA-DS - Input Sensor Tests
- FD-FF - Additional Input Component Tests
- G-J - Fuel Control System Tests
- KA-TG - PCM Output Tests
CIRCUIT TEST INDEX
| Circuit Test Title | Circuit Tested | |
|---|---|---|
| No-Start & Voltage Tests | ||
| AC | No Start (4.0L) | |
| B | Vehicle Battery | |
| C | Reference Voltage | |
| Input Sensor Tests | ||
| DA | IAT/ECT Sensor | |
| DC | MAF Sensor | |
| DF | MAP/BARO Sensor | |
| DG | Knock Sensor | |
| DH | Throttle Position Sensor | |
| DJ | Engine RPM Sensor | |
| DL | DPFE Sensor & EVR Solenoid | |
| DN | EVP Sensor & EVR Solenoid | |
| DP | Vehicle Speed Sensor | |
| DR | Cylinder Identification Circuit | |
| DS | Programmable Speedometer/Odometer Module | |
| Additional Input Component Tests | ||
| FD | Brake On-Off (BOO) Switch | |
| FE | Electrical Load Inputs | |
| FF | Power Steering Pressure Switch | |
| Fuel Control System Tests | ||
| G | MAF/TPS Fuel Injector Pulse Width Test | |
| H | Fuel Control | |
| HA | Adaptive Fuel | |
| J | Fuel Pump Circuit | |
| PCM (Processor) Output Tests | ||
| KA | EVR Solenoid | |
| KB | CANP Valve | |
| KC | Secondary Air Injection Solenoid | |
| KD | Canister Purge Solenoid | |
| KE | Idle Air Control Solenoid | |
| KM | WAC & A/C Demand Switch | |
| KP | Octane Adjust | |
| M | Dynamic Response Test | |
| ML | STO/MIL | |
| NC | IDM (4.0L) | |
| PC | Spark Timing Check (4.0L) | |
| QA | No Codes/Codes Not Listed | |
| QB | Continuous Memory Service Code 15 Or 512 | |
| QC | Output State Check Not Functioning | |
| S | System Check | |
| TA | CPP/PNP Switch | |
| TB | 4x4 Low/Transmission Control Switch | |
| TC | Transmission Solenoids | |
| TD | Manual Lever Position Sensor | |
| TE | Transmission Oil Temperature Sensor | |
| TF | Transmission Speed Sensor | |
| TG | Electronic Transmission Continuous Memory Service Codes | |