Rack & Pinion: Reassembly
- Inspect all parts and replace as required. Lubricate outer box assembly with ATF. Using Outer Box Torque Adapter (T88C-3504-CH), install outer box assembly.
- Stake outer box assembly to rack housing using a punch. Apply a thin coat of grease to sealing lips of pinion seal. Install pinion shaft seal using Pinion Bearing Replacer (T88C-3504-BH).
- Install pressure pad and spring into rack housing. Apply thread sealant to adjust cover. Using Yoke Torque Gauge (T88C-3504-AH), install adjust cover and tighten to 29-36 INCH lbs. (3.3-4.1 N.m). Loosen adjust cover 35 degrees. Using an INCH-pound torque wrench and Pinion Adapter (T88C-3504-BH), measure pinion torque. The torque should be 88.5-123.9 INCH lbs. (10-14 N.m).
- Install adjust cover lock nut. Tighten to 29-36 INCH lbs. (3.3-4.1 N.m). Mount rack in soft-jawed vise. Install tie rod assembly lock washer and tie rod. Tighten to 43-58 INCH lbs. (4.9-6.5 N.m). Bend lock washer tang to hold tie rod in place.
- Slide a dust boot over tie rod and secure it on rack and pinion with mechanic's wire. Ensure boot is not twisted or dented. Secure outer boot clamp. Install tie rod end. To complete installation, reverse removal procedure.