LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Explorer 4D Utility, RWD, Standard >> Repair and Diagnosis >> Suspension >> Wheel Alignment >> Wheel Alignment Specifications & Procedures >> Jacking & Hoisting >> Frame Contact Hoist >> Aerostar

Frame Contact Hoist: Aerostar

Vehicle may be raised on single-post or twin-post swiveling arm, or ramp-type drive hoist. If using single-post hoist, ensure lifting arms, pads or ramps are positioned at proper lifting points, and adequate underbody clearance is maintained. To ensure underbody clearance, place wooden blocks between lifting pads and frame at lift points. See Figure .

If vehicle is raised on a twin-post hoist, use caution not to damage suspension, rear axle cover and/or steering linkage components. Front end adapters should be carefully positioned, as near wheels as possible, to ensure maximum contact under center of lower suspension arms or spring supports.

Rear suspension hoist adapters (forks) should be placed under rear axle tubes. These adapters must not interfere with lower control arm mounting brackets or hydraulic brake tubes. To avoid damage, DO NOT allow hoisting forks to contact axle housing rear cover, stabilizer bar or brackets.