LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Explorer 4D Utility, 4WD, Automatic >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 4.0L >> Circuit Tests >> How To Use Circuit Tests >> Diagnostic Aids

Diagnostic Aids

Fuel-contaminated engine oil may affect some codes. If oil is suspect, remove PCV valve from valve cover and repeat QUICK TEST. If problem is corrected, change engine oil.

On CIRCUIT TEST H and CIRCUIT TEST J, vacuum leaks in non-EEC related areas may cause Code 41 or 91 to be displayed. Check vacuum motors, engine seals, EGR system, PCV system, Canister Purge (CANP), HEGO sensor and between airflow meter and throttle body for unmetered air leaks. Code 42 or 92 may be caused by fuel-contaminated engine oil, ignition misfire, or EGR system or CANP problems.

NOTE: In following tests, circuit diagrams and illustrations are courtesy of Ford Motor Co.

CIRCUIT TESTS are grouped as follows.

CIRCUIT TEST INDEX

Circuit Test Title Circuit Tested
No-Start & Voltage Tests
AC  No Start (EDIS)
B  Vehicle Battery
C  Reference Signal
Input Sensor Tests
DA  ACT/ECT Sensor
DC  Mass Airflow Sensor
DF  MAP Sensor
DH  Throttle Position Sensor
DP  Vehicle Speed Sensor
DS  Programmable Speedometer/Odometer Module
Additional Input Component Tests
FD  Brake On-Off (BOO) Switch
FE  Electrical Load Inputs
Fuel Control System Tests
G  MAF/TPS Fuel Injector Pulse Width Test
H  Fuel Control
HA  Adaptive Fuel
J  Fuel Pump Circuit
ECA (Processor) Output Tests
KA  EVR Solenoid
KD  Canister Purge
KE  Idle Speed Control
KM  WAC & A/C Demand Switch
KP  Octane Adjust
M  Dynamic Response Test
ML  STO/MIL
NC  EDIS Ignition Diagnostic Monitor
PC  Spark Timing Check (EDIS)
QA  No Codes/Codes Not Listed
QB  Continuous Memory Service Code 15 Or 512
QC  Output State Check Not Functioning
S  System Check
TA  Neutral Drive Input
TB  4x4 Low/Overdrive Cancel Switch
TC  Transmission Solenoids
TD  Manual Lever Position Sensor
TE  Transmission Oil Temperature Sensor