LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1992 >> Bronco 5.0 N, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 5.0L >> Circuit Tests >> How To Use Circuit Tests >> Diagnostic Aids

Diagnostic Aids

Fuel-contaminated engine oil may affect some codes. If oil is suspect, remove PCV valve from valve cover and repeat QUICK TEST. If problem is corrected, change engine oil.

On CIRCUIT TEST H and CIRCUIT TEST J, vacuum leaks in non-EEC related areas may cause Code 41 or 91 to be displayed. Check vacuum motors, engine seals, EGR system, PCV system, Canister Purge (CANP), HEGO sensor and between airflow meter and throttle body for unmetered air leaks. Code 42 or 92 may be caused by fuel-contaminated engine oil, ignition misfire, or EGR system or CANP problems.

NOTE: In following tests, circuit diagrams and illustrations are courtesy of Ford Motor Co.

CIRCUIT TESTS are grouped as follows.

CIRCUIT TEST INDEX

Circuit Test Title Circuit Tested
No-Start & Voltage Tests
AA No Start (TFI)
AB No Start (DIS)
AC No Start (EDIS)
B Vehicle Battery
C Reference Signal
Input Sensor Tests
DA ACT/ECT Sensor
DC Mass Airflow Sensor
DF MAP Sensor
DG Knock Sensor
DH Throttle Position Sensor
DJ Engine RPM Sensor
DN EVP Sensor & EVR Solenoid
DP Vehicle Speed Sensor
DQ Fuel Injection Pump Lever Sensor (7.3 Diesel)
DS Programmable Speedometer/Odometer Module
Additional Input Component Tests
FD Brake On-Off (BOO) Switch
FE Electrical Load Inputs
FF Power Steering Pressure Switch
Fuel Control System Tests
G MAF/TPS Fuel Injector Pulse Width Test
H Fuel Control
HA Adaptive Fuel
J Fuel Pump Circuit
ECA (Processor) Output Tests
KA EVR Solenoid
KC Air Management
KD Canister Purge
KE Idle Speed Control
KM WAC & A/C Demand Switch
KP Octane Adjust
M Dynamic Response Test
ML STO/MIL
NA TFI Ignition Diagnostic Monitor
NB DIS Ignition Diagnostic Monitor
NC EDIS Ignition Diagnostic Monitor
PA Spark Timing Check (TFI)
PB Spark Timing Check (DIS)
PC Spark Timing Check (EDIS)
QA No Codes/Codes Not Listed
QB Continuous Memory Service Code 15 Or 512
QC Output State Check Not Functioning
S System Check
TA Neutral Drive Input
TB 4x4 Low/Overdrive Cancel Switch
TC Transmission Solenoids
TD Manual Lever Position Sensor
TE Transmission Oil Temperature Sensor
TG Electronic Transmission Continuous Memory Service Codes