LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1991 >> Tempo LX, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Tests W/Codes - 2.3L >> Reading Codes >> KOEO & KOER Self-Test Codes >> Notes

KOEO & KOER Self-Test Codes: Notes

All service codes are 2 or 3-digit numbers. Codes are outputted, one digit at a time, by ECA. See appropriate chart under SERVICE CODE DEFINITION CHARTS for definitions of codes. These codes indicate current faults in the system, and should be serviced in the order of appearance. Use appropriate chart under SERVICE CODE REFERENCE CHARTS to find the correct CIRCUIT TEST. Codes are shown as voltage pulses (needle sweeps) on an analog Volt/Ohmmeter (VOM). See Figure.

If using VOM, pay careful attention to the length of pauses in order to read codes correctly. There is a 1/2-second pause between number of sweeps in a digit, and a 2-second pause between the digits in a code. There is a 4-second pause between each code. KOEO codes are separated from Continuous Memory codes by a 6-second delay, a single 1/2-second sweep (Separator) and another 6-second delay. Record codes in the order received.

If using "Scan" Tool, it will count the pulses and display them as a digital code. The STAR Series Tester will add a zero (0) to single-digit Separator Code (10) and Dynamic Response Code (10). The Dynamic Response Code is displayed in KOER SELF-TEST. See Figure.

If using CHECK ENGINE light, service codes are displayed as flashes. On Continental, the MESSAGE CENTER may be used to display codes. See Figure.