LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1989 >> Probe GT >> Repair and Diagnosis (Single Page) >> Steering >> Electronic Steering >> Steering Gear - Electronic >> Testing >> Notes

Steering Gear - Electronic: Testing: Notes

A thorough visual inspection should precede all VAPS testing. See TROUBLE SHOOTING and VAPS SYSTEM SELF-DIAGNOSTICS in this article, along with a corresponding circuit and connector wiring diagram. An Analog Volt-Ohm Meter (VOM) is needed to access VAPS test connector.

There is no warning light to signal driver about power steering control system problems. The control module does NOT store any fault codes. Trouble codes are accessed through VAPS test connector, below windshield wiper motor.

Information concerning possible problems can be gained through 3 specialized tests: KEY ON, ENGINE RUNNING TEST, CONTINUOUS MONITOR TEST and PINPOINT TESTS. The system's integrity and processing capability are tested. It also verifies sensors and actuators operate properly.

Repair any mechanical fault before testing or false diagnostic information may be obtained. Complete, in order, each test before going to PINPOINT TESTS or replacement of non-defective parts may result. Note location of 3-position slide switch on VAPS control module before entering diagnostics. See Fig 1 .

Fig 1: Three-Position Switch on VAPS Control Module
G107102Courtesy of FORD MOTOR CO.
NOTE: If vehicle passes all phases of KEY ON, ENGINE RUNNING TEST and CONTINUOUS MONITOR TEST, the problem may be mechanical. When directed to PINPOINT TESTS, look carefully at wiring diagram. Any time a repair is made, KEY ON, ENGINE RUNNING TEST should be repeated as a double check.