Test A2 - Vehicle Battery
NOTE:
Perform this test when directed here by A3, C2 or D13 test procedures.
To prevent replacement of good components, be aware that the following non-EEC related areas may be at fault: battery cables and ground straps, voltage regulator, alternator or ignition switch. This test should normally be conducted only when directed by CIRCUIT TEST A3, D23 or D13.
- Battery Voltage Check - Turn key on, leaving engine off. Set DVOM on 20-volt scale and measure voltage across battery terminals. If reading is less than 10.5 volts, service or replace discharged battery. If reading is 10.5 volts or more, go to next step.
- Checking EEC Ground Circuit - Turn key off and wait 10 seconds. Inspect ECA connector and pins. Install breakout box, leave ECA connected. Set DVOM on 200-ohm scale and measure resistance between Test Pin No. 40 and negative post on battery. Also measure resistance between Test Pin No. 60 and negative post on battery. If readings are greater than 5 ohms, repair cause of resistance in circuit(s). Repeat QUICK TEST . If both readings are less than 5 ohms, go to next step.
- Checking ECA Ground Insolation - With breakout box installed and ECA connected, turn key off and wait 10 seconds. Set DVOM on 200-ohm scale. Measure resistance between Test Pins No. 40 and 46 and between Test Pins No. 46 and 60 at breakout box. If both readings are less than 5 ohms, go to next step. If readings are greater than 5 ohms, disconnect ECA connector and inspect for corrosion or damaged pins. Repair if necessary. If fault is still present, replace ECA and repeat QUICK TEST .
- Continuity of Signal Return Circuit - With breakout box installed and ECA connected, turn key off and wait 10 seconds. Set DVOM on 200-ohm scale. Measure resistance between Test Pin No. 46 at breakout box and signal return circuit in SELF-TEST connector. If reading is greater than 5 ohms, repair cause of resistance in signal return circuit. Repeat QUICK TEST . If readings is less than 5 ohms, go to next step.
- Ignition Circuit Voltage - Turn key on, leaving engine off. With ECA connected, set DVOM on 20-volt scale. Measure voltage between battery negative post and ignition circuit at EEC power relay. If reading is less than 10.5 volts, check for open ignition switch circuits. Repair wiring and repeat QUICK TEST . If reading is 10.5 volts or more, go to next step.
- Checking Power Relay Ground Circuit Continuity - Turn key off and wait 10 seconds. With ECA connected and DVOM on 200-ohm scale, measure voltage between battery negative post and EEC relay ground. If reading is greater than 5 ohms, repair wiring in ground circuit. Repeat QUICK TEST . If reading is less than 5 ohms, go to next step.
- Checking Power Circuit (VPWR) at Relay - Turn key on, leaving engine off. With ECA connected and DVOM on 20-volt scale, measure voltage between battery negative post and VPWR circuit at EEC power relay. If reading is 10.5 volts or greater, repair open in VPKR circuit. If okay, repair short to ground in VPWR circuit. Repeat QUICK TEST .
- WIGGLE Testing VPWR Circuits - Turn key on, leaving engine off (KOEO). Connect VOM or diagnostic tester to SELF-TEST connector. With SELF-TEST deactivated, enter CONTINUOUS MONITOR SELF-TEST (WIGGLE TEST) . Observe VOM or diagnostic tester for indication of fault while bending and twisting ECA wiring harness.