Cold Engine
- Check and follow correct starting procedure listed on vehicle visor (if available). If vehicle starts, return vehicle to owner and explain starting procedure. If vehicle does not start, go to next step.NOTE: If ignition is left on and engine is not started within 2 minutes, the glow plug system must be reset by turning ignition off.
- Open hood. Listen for click from glow plug power relay when ignition is turned on. If click is heard, go to next step. If no click is heard, go to GLOW PLUG SYSTEM & DIAGNOSIS .
- Loosen one injector line nut 1/2 to one turn. Crank engine. If fuel discharges, go to ENGINE PERFORMANCE DIAGNOSIS in this article. If no fuel discharges, go to next step.
- Check energize to run solenoid terminal (located at front of injection pump) for dirt, loose connection or damage. While cranking engine, voltage at terminal must be at least 9 volts. If voltage is correct, go to ENGINE PERFORMANCE DIAGNOSIS in this article. If not, clean, repair, or replace terminal. After service, repeat this step.