Curb Idle Speed
- Start and run engine until it reaches normal operating temperature. Place transmission in Neutral (man. trans.) or "D" (auto. trans.). Ensure that curb idle adjusting screw is against stop. If not, adjust accelerator linkage.
- Using Photoelectric Tachometer (099-00001), check curb idle speed. Adjust idle speed to specification as indicated on Emission Tune-Up Decal in engine compartment. Use curb idle screw on side of pump for adjustment. See Figure.
- With transmission in "P" (auto. trans.) or Neutral (man. trans.), rev engine momentarily. Shift back into specified gear and recheck idle speed. Readjust if necessary.