2.5L HSC/CFI
Use this test procedure ONLY when directed to do so by results of QUICK TEST or steps in CIRCUIT TESTS . Follow test procedure carefully.
- When engine runs rough, misfires, stalls, lacks power, or idles roughly, perform the following checks:
- Perform SYSTEM CHECK, MAP Check. Use TEST QQ - SYSTEM CHECK , steps 2).
- Check MAP sensor, using TEST H - MAP SENSOR , step 12).
- Check EGR valve function.
- Check for, and repair, any bad ground or power connections.
- Check ignition components (cap, rotor, wires, coil, and plugs).
- Check basic engine components (valves, cam timing, compression, etc.).
- If engine idle speed is low with A/C on, turn ignition on. Perform KEY ON/ENGINE OFF SELF-TEST. If code 67 is present, go to TEST EE - IDLE SPEED CONTROL , step 9). If code 67 is not present, go to TEST O - NEUTRAL A/C SWITCH , step 9).
- If gasoline fumes accumulate in engine compartment, go to TEST CC - CANP CHECK , step 1).
- If engine stalls while parking vehicle, go to TEST R - PSPS , step 3).
- If engine idle speed is high in Drive (Auto. Trans. only), place transmission in "D" with engine off. Test Neutral/Drive Switch (NDS) circuit (test pin No. 30 on breakout box) for short to ground. Circuit should NOT have continuity to ground. If necessary, repair wiring.
- If engine stumbles after hot restart, check HEGO. Use TEST W , step 18).
- If shift indicator light is always on or off, go to TEST FF - SHIFT INDICATOR LIGHT , step 1).
- If "CHECK ENGINE" light is always on, go to TEST MM - "CHECK ENGINE" , step 1).
- If "CHECK ENGINE" light is never on, go to TEST MM - "CHECK ENGINE" , step 2).
- If fuel pump always runs, go to TEST SS - IRCM , step 14).
- If engine cooling fan does not work (Man. Trans. only), go to TEST SS - IRCM , step 32).
- If engine cooling fan, or if low (high) speed engine cooling fans do not work (Auto. Trans. only), go to TEST SS - IRCM , step 18).
- If low (high) speed engine cooling fans work all the time (Auto. Trans. only), go to TEST SS - IRCM , step 29).
- If A/C does not work, go to TEST SS - IRCM , step 39).
- If A/C does not cut off during wide open throttle (WOT), go to TEST SS - IRCM , step 41).
NOTE:
For updated idle speed circuit see Figure
.