LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1984 >> Cutaway 6.9 1 >> Repair and Diagnosis >> Engine Performance >> System >> Fuel Pump - Electric >> Testing >> Fuel Pump Operation

Fuel Pump Operation

  1. Disconnect fuel return line at throttle body. Connect hose from throttle body fitting to a calibrated container of at least 1 quart capacity. Connect pressure gauge (T80L 9974 A) to fuel diagnostic valve on fuel charging assembly.
  2. Disconnect connector to fuel pump just forward of fuel tank. Connect an auxiliary wiring harness to fuel pump. Energize pump for 10 seconds by connecting harness to a fully charged 12 volt battery. If fuel pump does not run, check connection at fuel pump.
  3. Fuel pump is operating properly if fuel pressure is 35-45 psi (2.5-3.2 kg/cm2 ) and if fuel flow is a minimum of 10 ounces. Fuel pump must maintain a minimum of 30 psi (2.1 kg/cm2 ) immediately after de-energization. If all 3 conditions are met, fuel pump is operating properly. Check for engine and electrical problems.
  4. If pressure conditions are met but flow is not, check for blocked filter(s) and lines. After correcting blockage, retest fuel pump. If flow is still not met, replace fuel pump. If fuel flow is met but pressure is not, check for worn or damaged pressure regulator valve on throttle body.
  5. If both pressure and flow conditions are met but pressure cannot be maintained after de-energization, check for leaking injector valve(s), and/or pressure regulator valve. If both check okay, replace fuel pump.