LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1984 >> Cutaway 6.9 1 >> Repair and Diagnosis >> Engine Performance >> System >> Fuel Injection System - 6.9L Diesel >> Testing >> Wait-To-Start Lamp Test B - Lamp Stays Lit With Key On

Wait-To-Start Lamp Test B - Lamp Stays Lit With Key On

  1. Turn ignition on. Disconnect latching relay. If lamp does not turn off, turn ignition off and repair grounded wiring between lamp and relay, then repeat Wait-To-Start Lamp Trouble Shooting. If lamp turns off, proceed with test.
  2. With relay disconnected, turn ignition on. Check voltage between relay connector pin 2 and ground. If voltage is 11 volts or more, proceed to step 3. If voltage is less than 11 volts, proceed to step 4.
  3. With relay disconnected, turn ignition off. Check resistance between relay connector pin 1 and ground. If resistance is 5 ohms or less, replace latching relay and repeat trouble shooting procedure. If resistance is more than 5 ohms, repair or replace wiring from latching relay to power relay and repeat trouble shooting procedure.
  4. With harness disconnected at latching relay and control switch, turn ignition off. Check harness resistance between relay connector pin 2 and switch connector pin 2. If resistance is less than 1 ohm, replace control switch and repeat trouble shooting procedure. If resistance is 1 ohm or more, repair or replace wiring from control switch to latching relay and repeat trouble shooting procedure.