LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1984 >> Cutaway 6.9 1 >> Repair and Diagnosis >> Engine Performance >> System >> Fuel Injection System - 6.9L Diesel >> Removal & Installation >> Injection Pump >> Installation

Injection Pump: Installation

Reverse removal procedures, noting the following: Install new "O"- ring on drive gear end of injection pump. Install injector lines using new copper gaskets in following sequence: 2,7,1,3,8,4,6,5. Purge injector lines by loosening connector 1/2 to 1 turn and cranking engine until a solid stream of fuel flows from connector. Check and adjust injection pump timing as necessary.

Fig 1: Injection Pump Line Sequence Remove and install injector lines in proper sequence.
G9752