LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1982 >> Bronco 5.0L Eng VIN F, Automatic Trans >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Columns >> Overhaul >> Tilt Column >> Reassembly

Tilt Column: Reassembly

  1. Attach PRND21 ring to tilt mechanism on automatics, or flange extension to tilt mechanism on manual 4 speed models. Attach key release lever mechanism to tilt mechanism on 4 speed manual transmission models.
  2. Install shift socket on automatic models. Install tilt mechanism, feeding the steering shaft down the center of the column and the ignition switch actuation rod through the shift socket/flange extension along the top of the column outer tube.
    NOTE: Care must be taken not to change the length of the steering shaft on "F" and Bronco models because of the telescoping feature.
  3. Install flange retainer assemblies using new hex screws. Install lower bearing retainer. Attach ignition switch loosely to the outer tube.
  4. Connect upper and lower actuators. Install cover on column. Install turn signal switch and wiring harness in steering column. Attach wiring harness to steering column clips. Install 2 screws attaching turn signal switch to the flange casting and 1 screw attaching warning buzzer terminal.
    Fig 1: Exploded View of Tilt Column Assembly
    G09318890Courtesy of FORD MOTOR CO.
  5. Install turn signal lever. Install lock drive gear. Install lock cylinder with key in "ON" position. Install the retaining pin flush with cylinder.
  6. With ignition switch mounting nuts loose, clip the switch through the opening in the side of the switch casting. Center the switch on the actuation rod. Tighten retaining nuts and remove clip.
  7. Install shift lever and pivot pin. Install turn signal lever. Install steering column and steering wheel.