LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1982 >> Bronco 5.0L Eng VIN F, Automatic Trans >> Repair and Diagnosis >> Steering >> Steering Column >> Steering Columns >> Overhaul >> Tilt Column >> Disassembly

Tilt Column: Disassembly

  1. Remove steering wheel. Remove column from vehicle. Remove turn signal lever. Drive out pivot pin and remove shift lever on automatic transmission models. Remove steering shaft lower flange and retaining clamp.
  2. Remove lower bearing retainer. On automatic transmission models, remove shift tube retaining screw from bottom of shift socket and withdraw shift tube from bottom of column.
  3. Remove lock drive gear. Remove turn signal switch screws, wiring harness to column clips and switch and wiring harness from column.
  4. Remove cover casting screws. Lift cover casting up and over the steering shaft and remove casting from column. Unhook upper actuator from lower actuator and remove.
  5. Remove and discard screws attaching lower flange to outer tube. Loosen ignition switch retaining screws and remove ignition rod from switch end.
  6. Withdraw tilt mechanism, steering shaft and ignition actuation rod from steering column upper end. Remove shift socket from automatic transmission models.
  7. Remove screws retaining flange extension on 4 speed manual transmission models, or PRND21 ring to tilt mechanism on automatics, or flange extension to tilt mechanisms on manual 4 speed models. Attach key release lever mechanism to tilt mechanism on 4 speed manual transmission models.