LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1982 >> Bronco 5.0L Eng VIN F, Automatic Trans >> Repair and Diagnosis >> Engine Performance >> Tune-Up >> Tune-Up - V8 >> Ignition Timing

Ignition Timing

NOTE: Magnetic probe timing device may be used if instrument is available and engine is so equipped. Timing probe offset is 135° ATDC on all V8 engines.
  1. Determine specified timing and mark degree line on damper (some vehicles mark both pointer and damper notch). Disconnect vacuum line(s) at distributor and plug.
  2. Connect tachometer. Connect timing light to No. 1 spark plug wire. Set timing to specifications if more than 2° variation is found.
  3. To adjust, loosen distributor hold-down bolt and rotate distributor to align marks in step  1). Tighten hold-down bolt and recheck timing.
TIMING SPECIFICATIONS (Degrees BTDC@RPM)

Application Man. Trans. Auto. Trans.
4.2L 8@800 8@800
5.0L
  Calif. (1) (1)
  High Altitude 12@800 12@800
  All Other Models 8@800 8@800
5.8L
  Calif. (1) (1)
  Light Duty 14@800 14@800
  Heavy Duty (2) 6(9) 800 (3) 6@800
6.6L 6@800 (4) 6@800
7.5L 8@800 8@800
(1) Calif. 5.0L & 5.8L engines are equipped with Electronic Engine Control (EEC III) system and no adjustment is required.
(2) Set calibration numbers 2-76J-R18 to 5@800, 2-76J-R20 to 8@800.
(3) Set calibration numbers 2-75J-R18 to 5@700, 2-75J-R20 to 8@700.
(4) Set calibration number 2-9-74J-R13 to 3@800.