LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1982 >> Bronco 5.0L Eng VIN F, Automatic Trans >> Repair and Diagnosis >> Electrical >> Body Electrical >> Cruise Control Systems >> Testing >> Clutch Switch Test >> Bronco & "F" Man. Trans. Models

Bronco & "F" Man. Trans. Models

NOTE: Switch operates magnetically. Do not use magnetized tools near switch. Use only a voltmeter of 5, 000 ohm/volt rating or higher to test switch. Test lamp will not indicate switch condition.
  1. Check if clutch switch plunger is depressed (switch closed) when clutch pedal is released. Speed control will not operate unless this condition exists.
  2. Disconnect clutch switch connector from speed control harness connector, and connect an ohmmeter to switch connector terminals. With clutch pedal released in "full-up" position and switch plunger depressed (switch closed), resistance should be less than 5 ohms.
  3. With clutch pedal depressed and switch plunger fully extended (switch open), resistance should be "infinity".