LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1965 >> P-100 Automatic Trans >> Repair and Diagnosis >> Steering >> Steering Linkage >> All Models W/Straight "I" Beam Axle >> Center Link End Replacement

Center Link End Replacement

  1. Remove cotter pin and nut from link end ball stud. Remove ball stud from spindle arm. Loosen clamp and turn link end out of link. Lubricate threads of new link end and screw into link about same distance as old unit to approximate original toe-in setting.
    Fig 1: Steering Linkage W/Straight "I" Beam Axle
    G09348876Courtesy of FORD MOTOR CO.
  2. Install ball stud in spindle arm, tighten nut to specifications, and install cotter pin. Check toe-in and adjust as required. Check that link end clamps are 3/16" from end of link with clamp bolt at right angles to slot in end of link. Check that clamp does not interfere with steering movement from full-left to full-right positions.